UBNT AirOS Version 5.5 release
Supported products :
- Bullet M, Titanium
- Rocket M
- NanoStation M
- AirGrid M / AirGrid HP M
- NanoBridge M
- PowerBridge M
- PicoStation M
- NanoStation Loco M
- AirRouter
- PowerAP N
- Rocket M365
- Rocket M900
- NanoStation M365
- NanoStation Loco M900
- NanoBridge M365
- NanoBridge M900
- NanoBridge M3
- PowerBridge M10
AirOS Version 5.5 - Final Release (April 10, 2012)
New product support:
- New: Bullet M2 Titanium
- New: Bullet M5 Titanium
New functionality:
- New: Management VLAN support
- New: Advanced network settings configuration mode
- New: RADIUS MAC authentication
- New: Low TX power mode support for all M series models
- New: AirMax client support for 802.11 a/b/g products
- New: DHCP relay functionality in Router/SOHO Router mode
- New: UPnP server support in Router/SOHO Router modes
- New: Ability to Block WAN Access in SOHO Router mode
- New: Fallback IP for PPPoE client
- New: 3/8 MHz channel width support for M900
- New: 8/30 MHz channel width support for M2/M5
- New: 8/25 MHz channel width support for M3
- New: 25 MHz channel width support for M365
- New: Full range of channel width options in Compliance mode
- New: Max allowed MTU size for newer HW revision models is 2024 bytes
- New: Make Device name the Product Model by default
- New: Separate throughput graphs for LAN0/LAN1 interfaces
- New: Option to create support info file with ping watchdog before device reboot
- New: Enable/Disable CDP option in Device Discovery section
- New: Check for existing uploaded firmware image when opening System page
- New: Prepare for IPv6 support
- New: Traffic shaper for ingress traffic
- New: Notification for software updates
- New: Add PPPoE service name configuration
- New: Kernel patches for SIP conntrack/NAT support
- New: Show AirMax priority in Main page for Station mode
Fixes:
- Fix: Configuration change causes device with a long uptime to lock up
- Fix: Device stops passing traffic after some time and requires a reboot or "kick" to work again
- Fix: Dynamic DNS update after PPPoE session initialization
- Fix: Station list is empty when there are few stations associated
- Fix: Port ID is mandatory in CDP packet
- Fix: STA-WDS in bridge mode is passing back multicast/broadcast packets
- Fix: "Antenna Gain" and "Cable Loss" fields are locked for LocoM900 with external antenna
- Fix: Incorrect connection time reporting
- Fix: Timestamps reset because of stuck beacon. Causes other manufacturers' (i.e. Tranzeo) devices to re-associate.
- Fix: Can't launch airView with HTTPS enabled on IE8
- Fix: Traceroute fails to DNS host with multiple addresses
Improvements/Change requests:
- Improvement: Linux kernel update to 2.6.32 version
- Improvement: AirMax performance in large PtMP networks
- Improvement: AirSync performance in PtMP networks
- Improvement: ACL List: Dynamic list now allows instant changes (no restart or dropped connections required)
- Improvement: ACL List: MAC list limit increased from 64 to unlimited
- Improvement: ACL List: Ability to add comments to MACs
- Improvement: ACL List: Ability to enable/disable a MAC without removing it from the list
- Improvement: DFS functionality improvement according FCC/ETSI requirements
- Improvement: Report Horizontal / Vertical antenna instead of "Chain 0 / Chain 1"
- Improvement: New look for wireless mode configuration
- Improvement: Various WEB GUI tweaks, changes, improvements
- Improvement: Send NASID in Access-Request packet.
- Improvement: Add internal speed test tool to DMZ exemption ports
- Improvement: Hide Discovery Tool for read-only account
- Improvement: Extension for Port Forward configuration. Allow to specify Public IP
Regional Updates:
- New: Initial Login page with Country/Language selection
- New: Replace Obey Regulatory rules with Auto Adjust to EIRP Limit functionality
- New: Remove possibility to change country for some countries (USA, Spain)
- New: Remove indoor range for Brazil (5.1-5.3GHz frequencies)
- New: Show Band C for UK Frequencies
- New: Add Iraq country code
- New: Add Nigeria country code
- New: EIRP limits for US Regdomain on 2.4GHz and 5.8GHz band
- New: Add German translation
- Fix: Regulatory rules update for Australia
- Fix: Devices with selected country Ukraine doesn't work in 5GHz band
Additional Notes:
- Note: SNMP interface indexes have changed with v5.5 due to advanced network configuration options
- Note: AirControl v1 Configuration changes are not supported with v5.5 firmware
- Note: Possible Web UI issues with out of date browsers (i.e. Firefox 3.6). It's recommended to use current browser software
Test on Bullet M2HP
For Download Here
0 komentar:
Post a Comment